
Bob Hope Airport (KBUR) Burbank - California by Ray Smith

These 2 BGL files were designed with the latest version of ADE (v1.26) and made only for the FSX default airport: one with the Crosswind rwy operating, now activated by ADE where both rwy's will be used for takeoff/landing and one as default: assigned parking with extra parking, missing gates added where possible and numbered in the correct order, helipad added, Taxiway's D8 and BB corrected along with the taxisigns, extra fuel trucks, suport vehicle roads rebuilt and many other improvements, airport views are from the roof of the control tower (when in tower view) fully tested with Ultimate Traffic/WOAI but not required, please view the readme before installation


There are 2 BGL files: KBUR_ADE_RS.BGL and KBUR_ADE_CW_RS.BGL

The 'KBUR_ADE_CW_RS.BGL' version is with the Xwind rwy activated, the other version KBUR_ADE_RS.BGLis without 
parking is the same in both......


PLEASE NOTE: when using ATIS with the KBUR_ADE_CW_RS.BGL file you will hear the fake rwy's, this is the method used in activating Xwind rwy's created by Jim Vile and should be ignored or if prefered use the version KBUR_ADE_RS.BGL


To Install:

1. simply take the BGL file of your choice and place it into: Flight Simulator X/Addon Scenery/scenery folder

2. Start up the Flight sim and the changes will be present

NOTE: PLEASE ONLY USE ONE BGL FILE AT A TIME:
  ie: make sure there is only ONE 'KBUR.BGL' FILE in the Addon Scenery/scenery folder at any time, remove/delete any other KBUR.bgl to avoid incorrect parking

To Uninstall:

1. Delete/remove the BGL file and the default will then be active.





         Acknowledgements
  _________________________________


ADE Utility - Jon Masterson.........http://www.scruffyduckscenery.co.uk

Please visit here for more information...........http://www.airportdesigneditor.co.uk

Any questions relating to ADE can be answered at www.fsdeveloper.com/forum......look for Airport Design Editor

Jim Vile for his Technique that activates crosswind runways



TIP: when at KBUR in tower view: go to your control settings and look for the "View track/pan Toggle"
allocate a keyboard key stroke to it (i allocated a button on my X52 controller) this will unlock the user aircraft, then you can use the hat switch to pan 360 degrees around the airport, hitting the key stroke again (in my case a button) will return you to the user aircraft position

Enjoy and Happy flying

cry@orcon.net.nz
                          Ray      :-)

