EMBRAER ERJ190-LR Procedures

EMBRAER ERJ190-LR

For detailed instructions on how to fly this aircraft, see the 737-400 Aircraft Information articles in the Learning Center. For suggested speeds, see the Reference page of the Kneeboard. Note that most actions can also be performed using the mouse.

To...	Press...
Display/hide TCAS	SHIFT+2
Display/hide GPS 500	SHIFT+3
Display/hide RADIO STACK	SHIFT+4
Display/hide GROUND HANDLING	SHIFT+5
Display/hide THROTTLE QUAD	SHIFT+6
Display/hide OVERHEAD PANEL	SHIFT+7
Display/hide PRIMARY FLT DISP	SHIFT+8
Display/hide MULTI FUNC DISP	SHIFT+9

PUSHBACK (if parked at a gate)

[ ] Pushback	REQUEST (press SHIFT+P, then 1 for tail-left or 2 for tail-right, then press SHIFT+P to stop)

BEFORE START

[ ] Parking Brake	SET (press CTRL+PERIOD key)

ENGINE START

Press CTRL+E to initiate engine autostart sequence.

AFTER START

[ ] Engine Start Switches	CHECK GEN
[ ] Pitot Heat	ON
[ ] De-ice	AS REQUIRED
[ ] Engine Thrust Levers	CHECK IDLE
[ ] Lights	AS REQUIRED
[ ] Autopilot	SET and OFF
[ ] Instruments	CHECKED
[ ] Autobrake Switch	RTO (Ground Handling)
[ ] Avionics Switch	ON
[ ] Avionics	SET (press SHIFT+2 to display radio stack)

DURING TAXI/BEFORE TAKEOFF

[ ] Brakes	RELEASE (press PERIOD key)
[ ] Thrust Levers	INCREASE SLIGHTLY TO ROLL (press F3 or F2 as necessary)
[ ] Thrust Levers	IDLE FOR TAXI (press F2 or F3 as necessary)
[ ] Flight Controls	CHECK
[ ] Flaps	SET FOR TAKEOFF (5) (press F7 as necessary)
[ ] Brakes	SET (press PERIOD key)

CLEARED FOR TAKEOFF

[ ] Engine Start Switches	GEN
[ ] Flight Director	ON
[ ] Autothrottle	ARM (if using TO/GA mode for takeoff)
[ ] Transponder	ON (press SHIFT+2 to display radio stack)
[ ] Lights	AS REQUIRED

TAKEOFF

[ ] Brakes	RELEASE (press PERIOD key)
[ ] Thrust Levers	ADVANCE SMOOTHLY TO 40% N1 (press F2 or F3 as necessary)

--WAIT FOR ENGINE STABILIZATION--

[ ] Thrust Levers	ADVANCE SMOOTHLY TO 100% N1 (press F2 or F3 as necessary)
--or--
[ ] TO/GA Mode	ENGAGE (press CTRL+SHIFT+R)
[ ] Engine Instruments	MONITOR
[ ] Airspeed 80 KIAS	CALLOUT "80 KNOTS"

-- VERIFY PROPER THRUST SET--

[ ] Airspeed V1	CALLOUT "V1"
[ ] Airspeed VR	CALLOUT "ROTATE"

--ROTATE TO APPROX. 10 DEGREES PITCH UP--

[ ] Airspeed V2	CALLOUT "V2"
[ ] Landing Gear	UP (WHEN POSITIVE CLIMB ESTABLISHED) (press G)
[ ] Airspeed	MAINTAIN V2+20 KIAS
[ ] Autopilot	ENGAGE AT 1,000' AGL
[ ] Flaps	RETRACT TO 8 AT 1,000' AGL (press F6 until 1)
[ ] Flaps	UP AT 210 KIAS (press F6 until Up)
[ ] Autothrottle	OFF
[ ] Thrust Levers	90% N1 (press F2 or F3 as necessary)
[ ] Airspeed	250 KIAS AT 3,000' AGL
[ ] Landing Gear Lever	Verify UP

CLIMB

[ ] Airspeed	MAINTAIN 250 KIAS
[ ] Landing Lights	OFF ABOVE 10,000' MSL
[ ] Airspeed	280 KIAS ABOVE 10,000' MSL
[ ] Altimeter	SET TO 29.92 CROSSING 18,000' MSL

CRUISE

[ ] Thrust Levers	AS DESIRED (press F2 or F3 as necessary)
[ ] Trim	AS NECESSARY (press Num Pad 1 or Num Pad 7 as necessary)

DESCENT

[ ] Autobrake Switch	AS DESIRED
[ ] Airspeeds (VREF, VAPP)	COMPUTED and SET (see the Reference page of the Kneeboard)
[ ] De-ice	AS REQUIRED
[ ] Autopilot	AS DESIRED
[ ] Thrust Levers	AS DESIRED (press F2 or F3 as necessary)
[ ] Altimeter	SET TO LOCAL SETTING CROSSING 18,000' MSL
[ ] Avionics	SET
[ ] Airspeed	<250 KIAS BELOW 10,000' MSL
[ ] Landing Lights	ON BELOW 10,000' MSL
[ ] Approach Procedure	REVIEW
APPROACH

[ ] Airspeed	AS DESIRED
[ ] Thrust Levers	AS DESIRED (press F2 or F3 as necessary)
[ ] Flaps	AS DESIRED (press F7 as necessary)
[ ] Autopilot	AS DESIRED
[ ] Autothrottle	ARM (if using TO/GA mode for go-around)

LANDING

[ ] Airspeed	AS DESIRED
[ ] Thrust Levers	AS DESIRED (press F2 or F3 as necessary)
[ ] Speedbrake	ARMED (press SHIFT + / [FORWARD SLASH key])
[ ] Landing Gear	DOWN AND CONFIRMED (press G)
[ ] Flaps	AS DESIRED (press F7 as necessary)
[ ] Start Switches	GEN
[ ] Autopilot	AS DESIRED

LANDING ROLL

[ ] Thrust Levers	IDLE (press F2 or F3 as necessary)
[ ] Autopilot	CHECK DISENGAGED
[ ] Autothrottle	CHECK OFF
[ ] Speedbrake Lever	CHECK FULL UP (press SHIFT+/ [FORWARD SLASH key] if necessary)
[ ] Brake	AS NECESSARY (press PERIOD key)
[ ] Thrust Levers	REVERSE (press F2 until Reverse)
[ ] Thrust Levers	IDLE AT 60 KIAS (press F3 until Idle)

TAXI-IN

[ ] Speedbrake Lever	DN (press / [FORWARD SLASH key])
[ ] Flap Lever	UP (press F6 until Up)
[ ] Pitot Heat	OFF
[ ] Engine Start Switches	AS DESIRED
[ ] Landing Lights	AS DESIRED
[ ] Flight Director	OFF
[ ] Transponder	AS REQUIRED

PARKING

[ ] Parking Brake	SET (press CTRL+PERIOD)
[ ] Start Levers	CUTOFF (press CTRL+SHIFT+F1)
[ ] De-ice	OFF
[ ] Lights	AS REQUIRED
[ ] Speedbrake Lever	DOWN (press / [FORWARD SLASH key] if necessary)
[ ] Transponder	AS REQUIRED

NOTE: This aircraft's real-world checklists have been modified for use with Flight Simulator.