DeHavilland DHC2-MKIII Turbo Beaver
REFERENCE INFORMATION

For detailed instructions on how to fly this aircraft, see the Aircraft Information
articles in the Learning Center. For standard procedures, see the Checklists tab.  

Total Flight Simulator aircraft weight with full fuel   5,370 lbs


NOTE: To adjust fuel load, on the Aircraft menu, click Fuel and Load.
 

VA - Maneuvering Speed (5,370 lbs) 124 KIAS
VMO - Maximum Operating Speed 176 KIAS
VNO - Max Structural Cruising Speed 141 KIAS
VNE - Never Exceed Speed 180 KIAS
VS - Stalling Speed (max weight, flaps up) 65 KIAS
VSO - Stalling Speed in Landing Configuration 51 KIAS
VX - Best Angle-of-Climb Speed (sea level) 81 KIAS
VY - Best Rate-of-Climb Speed (sea level) 97 KIAS
Maximum Glide Speed (5,370 lbs) 87 KIAS

Maximum Flap Placard Speeds

Flaps degrees   

KIAS

15

140

35

120

50

100

58-full flaps 90

NOTE: For explanations of speeds used on this tab, see "V-speeds" in the Learning Center Glossary.

Quick Reference - Annunciator

Quick Reference - Ground Handling 5.0 for FSX

Quick Reference - Panel Help


+++NOTAMS+++

Open the Panel_Docs folder for information on operating this aircraft.

**** VERY IMPORTANT ****
Although the groundhandling5 gauge doesn't use FSUIPC itself
if you have the unregistered version of FSUIPC V4.0.0 or V4.0.1
(the very first FSX versions) installed
you MUST upgrade to V4.0.2 or higher
otherwise the Pushback-turn will not work.
If you haven't got a clue what FSUIPC is
then just ignore this remark.

**** IMPORTANT--IMPORTANT--IMPORTANT****
Due to differences in the Brakes implementation in FSX
with respect to the use of Toebrakes pedals,
activate (remove the "//" in front of the line)
gauge03= ONLY when you use proportional
toebrake pedals, like the CH Pro Pedals.
Removing the "//" will force the
Taxispeed gauge to use proportional Brake
commands (like your pedals)
instead of normal Brake commands.

Turn on Tool Tips

To raise your seat higher press SHIFT-ENTER

Use Shift E to open the Pilot Doors...

Shift E +2 will operate the Passenger Doors

Important... If using AUTOSTART (CTRL E) .... Check to make sure the Generator is switched to ON in the lower IFR panel or VC

To hear the Exit Door sounds....It has to be quiet in the cockpit Do it before starting engines or after Engine Shutdown

Use of Elevator trim is recommended in FS2004

For Best Frame Rates...Keep Windows Closed

===============================

Quick Reference - EYEPOINT KEY COMMANDS

Move Eyepoint Back
CTRL+ENTER
Move Eyepoint Down
SHIFT+BACKSPACE
Move Eyepoint Forward
CTRL+BACKSPACE
Move Eyepoint Left
CTRL+SHIFT+BACKSPACE
Move Eyepoint Right
CTRL+SHIFT+ENTER
Move Eyepoint Up
SHIFT+ENTER
Reset Eyepoint
SPACE

Copyright ©  2006 - Premier Aircraft Design